4种胡桃科坚果中氨基酸和脂肪酸组成分析与营养评价

为对我国不同种类胡桃科坚果的高阶营养(氨基酸和脂肪酸组成)进行比较和评价,选取产自浙江、安徽、甘肃、陕西、四川、新疆6省的4种胡桃科坚果(普通核桃(Juglans regia Linn.)、泡核桃(Juglans sigillata Dode)、山核桃(Carya cathayensis Sarg.)、薄壳山核桃(Carya illinoensis (Wangenh.) K. Koch)),参照国标方法对其氨基酸与脂肪酸组成进行分析,利用必需氨基酸指数、氨基酸匹配度与平衡度评价、氨基酸比值系数评价法和脂肪酸指数评价法分别对氨基酸与脂肪酸组成进行营养评价。结果表明,泡核桃与普通核桃总氨基酸含量较高,4种坚果中必需氨基酸含量占总氨基酸含量的1/3左右,总氨基酸与必需氨基酸含量呈正相关关系。非必需氨基酸中天冬氨酸、谷氨酸、精氨酸含量较高。新疆阿克苏泡核桃在必需氨基酸指数与氨基酸匹配度的评价结果中为最优,4种胡桃科坚果氨基酸平衡度较为相近。氨基酸比值系数评价法显示浙江临安山核桃最优,新疆阿克苏泡核桃次之。4种胡桃科坚果中山核桃和薄壳山核桃中油酸含量较高;泡核桃和普通核桃中亚油酸含量较高。研究结果为胡桃科坚果的育种、生产与加工提供了一定的基础数据。     

生物质电厂废弃物草木灰成分分析及成形

生物质热电厂焚烧废弃物的主要成分是草木灰，其产生量大、密度小。大量草木灰不经处理会造成环境污染问题。本文首先分析草木灰的化学成分，确定草木灰的肥料特征，通过添加NH₄H₂PO₄使草木灰的pH达到国家复合肥的相关标准。选用聚天冬氨酸（30%水溶液）作为复合肥的黏结剂，应用于草木灰复合肥的成形造粒，以增加其抗压强度和肥效。研究不同烘干时间、烘干温度、聚天冬氨酸添加量对草木灰复合肥抗压强度的影响规律，通过分析植物的形态及生理指标，进而研究草木灰复合肥的肥效。结果表明：最佳烘干条件为10h、140℃，聚天冬氨酸对草木灰的抗压强度有明显的增强作用，并且草木灰与聚天冬氨酸的复配比为6g∶1mL时肥效最好。此方法解决了元素循环中断、草木灰环境污染，在运输过程中草木灰复合肥易碎，纯草木灰肥效低等问题。     

Selective hydrogenation of levoglucosenone over Pd/C using formic acid as a hydrogen source

Selective hydrogenation of lignocellulosic biomass-derived chemicals is of great importance for future energy and chemical supply. So far formic acid is considered as one of the most promising materials for hydrogen storage. Herein, we report a novel pathway for the hydrogenation of Levogluosenone (LGO), a biorenewable platform chemical, to dihydrolevoglucosenone (Cyrene) and levoglucosanol (Lgol) using formic acid as a hydrogen source. Testing with typical hydrogenation catalysts indicated the crucial influence of the type on reaction selectivity and identified Pd/C as the most suitable catalyst. Among solvents screened, THF in combination with Pd/C showed the best performance for LGO hydrogenation, producing Cyrene in >99% yield at a low temperature (60 °C). Nevertheless, hydrogenation of Cyrene to Lgol required a harsher condition as a result of the difficult reduction property of its C=O bond. Elevating the reaction temperature to 180 °C and increasing double Pd dosage enabled a high yield of Lgol, attaining to 94.8%.     

工业用氢氧化钠中铁含量的测定

简述了用分光光度法测定工业氢氧化钠中铁含量的原理和试验步骤,通过多次试验寻找出影响测铁准确度的方法,并且对其结果进行分析和探索。     

MAPP/EAA处理对聚丙烯/小麦秸秆粉复合材料性能的影响

研究了马来酸酐接枝聚丙烯（MAPP）、乙烯丙烯酸共聚物（EAA）处理对聚丙烯（PP） /小麦秸秆粉（WSP）复合材料性能的影响。结果表明，随着体系中MAPP质量份数的增加，PP/WSP的拉伸强度和弯曲强度均逐渐增大，但冲击强度却先增加后减小，复合材料达到塑化峰的时间逐渐延长；使用EAA后，无论体系中是否已经使用了MAPP，PP/WSP的拉伸、弯曲和冲击强度均可得以提高，特别对于未使用MAPP的体系，效果更加明显，可分别提高65.04 %、45.42 %和6.75 %，储能模量增加，表面疏水性增强，平衡扭矩从13.9 N·m降至11.8 N·m，吸水尺寸变化率及吸水率下降，吸水平衡时间缩短；使用EAA可改善PP/WSP中WSP与PP间的界面结合，改善PP/WSP力学性能、热稳定性能、表面疏水性能、尺寸稳定性能和加工性能，降低其吸水率。     

湿法磷酸净化脱砷的研究现状

随着食品、医药及电子行业的不断发展，磷酸及磷酸盐的市场需求量不断增大，并且对磷酸的品质要求也越来越高，尤其是对湿法磷酸中砷杂质的要求，湿法磷酸中砷的含量将直接影响其在磷精细化工领域的应用，因此湿法磷酸中砷的高效、安全去除是亟待解决的一大难题。本文主要对湿法净化磷酸脱砷技术的研究情况进行综述，比较了几种湿法净化磷酸脱砷工艺的优缺点，介绍了较常见的化学沉淀法、结晶法，以及新兴的电沉积法、垂直区域熔融法和微反应器脱砷工艺的应用前景，并指出这些新兴的脱砷工艺将成为今后湿法磷酸的净化脱砷的发展方向，如能解决将这些脱砷工艺在实际中的问题，将会对磷酸工业的发展提供一个更有力的支持。     

水性锈转化涂料的制备及性能

采用苯丙乳液与改性苯丙乳液共混作为成膜物质,以单宁酸为转锈剂,柠檬酸为配位剂,焦性没食子酸为转锈促进剂,再加入成膜助剂、有机胺类缓蚀剂、渗透剂等,制备了一种可应用于带锈钢材的水性锈转化涂料。通过正交试验和单因素试验确定了涂料的最优配方为:成膜物质65%,转锈剂5%,转锈促进剂2%,缓蚀剂0.6%,渗透剂2%,配位剂0.5%,成膜助剂1.6%,蒸馏水余量。采用塔菲尔极化曲线测量、中性盐雾试验和盐水浸泡试验考察了漆膜的耐蚀性。结果表明,所制水性锈转化涂膜可耐盐雾96 h,耐盐水浸泡168 h,且耐酸性较强,在pH为2的3.5%NaCl溶液中有保护作用。与两款市售涂料相比,该自制水性锈转化涂料具有更好的耐蚀性。     

Separators for alkaline water electrolysis prepared by plasma-initiated grafting of acrylic acid on microporous polypropylene membranes

Highly hydrophilic separators for alkaline water electrolysis were prepared by plasma-initiated grafting of acrylic acid on porous polypropylene (PP) membranes. The membranes were activated in a low-pressure radio-frequency discharge in oxygen and subsequently graft polymerization of acrylic acid was performed in aqueous solution. The membranes were characterized by gravimetric grafting degree (GD), SEM, FTIR, critical wetting surface tension (CWST) test, mechanical strength, and electrolytic conductivity. Moreover, the membranes were applied as separators in alkaline electrolysis cell, and content of hydrogen in the produced oxygen was measured to determine membrane permeability to hydrogen dissolved in the electrolyte. It was observed that increasing GD improves performance of membranes as separators in alkaline electrolysis, although the particular effects on the electrolytic conductivity and hydrogen permeability strongly depend on structure the of initial PP substrate. Ageing test conducted in 30 wt% KOH at 60 °C revealed that although considerable degrafting took place at beginning of the test, the remaining polyacrylic acid provided highly hydrophilic character to membrane for 7000 h of the test.     

Characterization of the ash deposits along deep-cooling of the exhaust gas in coal-fired power plants

Ash deposition and condensation of acid vapors under deep-cooling of exhaust gas in a 1000 MW ultra-supercritical power plant were investigated. X-ray diffraction, X-ray fluorescence and laser particle size analyzers were employed to characterize the components, elements and particle size distribution of deposits at different metal wall temperatures. The results show that the deposits formed at the metal wall temperatures of 40 °C–60 °C were much thicker than the deposits at 70 °C–90 °C from the perspectives of the morphology and thickness. Fluorides and chlorides were observed in deposits formed at the metal wall temperatures of 40 °C–60 °C. Thin deposits were composed of Al-Si oxides and simple sulfates when the metal wall temperatures were 70 °C–90 °C. The dew-point temperatures of water, HCl and HF vapors were around 40 °C, 60 °C, and 60 °C, respectively. Basic ferric, aluminum and calcium sulfates, which were acted as traps to absorb the condensate and fly ash. Hydration played an important role in the growth of deposits formed at the metal wall temperature of 40 °C–60 °C.     

加压酸浸法从烟化炉冰铜中浸出铜和镍的试验研究

烟化炉冰铜主要是采用烟化炉处理低品位铜、锡、镍、锌等物料时产生的中间产物，主要含铜、镍、铁、硫等元素，从中浸出铜和镍具有重要价值。采用加压酸浸法从烟化炉冰铜中浸出铜和镍，试验研究了时间、温度、氧分压、液固比、粒度等因素对铜、镍、铁浸出率的影响。试验结果表明：烟化炉冰铜粒度球磨至小于75μm、温度433K、时间3h、氧分压为0.6MPa、液固比4/1mL/g、木质素磺酸钠用量为2‰的优化条件下，铜、镍、铁浸出率分别平均为98.18%、98.42%和26.46%。